revision 11/16/2011 www.phihong.com 19.6w single port po wer over ethernet midspan ieee802.3af compliant power injector features ? compliant with ieee802.3af standard ? limited power source ? non-vented case ? gigabit compatible ? full protection ovp, ocp ? 1 year warranty applications ? ip telephones ? security cameras ? wireless access points ? ip print servers ? bluetooth ? access points ? wimax ? access points safety approvals ? ce ? cul/us mechanical characteristics ? length: 140mm (5.51in.) ? height: 36mm (1.42in.) ? width: 65mm (2.55in.) ? weight: 0.2kg (7.58oz) output specifications phihong is not responsible for any error, a nd reserves the right to make changes wit hout notice. please visit our website at www.phihong.com for the most up-to-date spec ifications and cont act information. model ac input dc output voltage load regulation min. max. line load POE21U-1AF three wire 56v 10ma 350ma 5% poe21w-1af two wire 56v 10ma 350ma 5%
revision 11/16/2011 poe21x-1af characteristics www.phihong.com input: ac input voltage rating 100 to 240vac ac input voltage range 90 to 264vac ac input current 0.8a (rms) maximum at 120vac 0.55a (rms) maximum at 240vac ac input frequency 47 to 63hz leakage current u model ? 350ua maximum w model ? 250ua maximum max in-rush current 60a maximum at 240vac and maximum load (cold start at ambient 25c) output: output power 19.6w hold up time 10msec minimum at maximu m load at 120vac, 60hz transient o/p voltage protection 60v maximum at switch on/off at any ac line phase efficiency 80% typical at maximum load at 120vac, 60hz environment operating temperature 0 to +40c non-operating temperature -20 to +65c relative humidity 5 to 90% emi en55022 class b fcc part 15 class b emc esd: iec61000-4-2 level 3 rs: iec61000-4-3 level 3 eft/burst: iec61000-4-4 level 2 surge: iec61000-4-5 level 3 cs: iec61000-4-6 level3 voltage dips: iec61000-4-11 harmonic: iec61000-3-2 class a isolation (hi-pot) primary to secondary: 1500vac for 1 minute, 10ma insulation resistance primary to secondary: 10m ohm 500vdc features: cisco no extern parts required for legacy devices: voip phones: 7910, 7912, 7940, 7960 access points: 1040, 1140, 1250, 1260, 3500 over voltage/current, short circuit protection the output is equipped with short-circuit protection and overload protection as per the ieee 802.3af specification and conforms to ul60950-2. the output can be shorted permanently without damage. indicator (status) solid green: valid ieee802.3af load detected and connected ?on? blinking green: power ?on? ready for connection blinking red/green: invalid load connected blinking red: fault ac input connector u models - iec320 inlet 3-pin c14 w models ? iec320 inlet 2-pin c8 output connection +pins 3,6 / -pins 1,2 data in/poe out connector rj45 warranty 1 year dimension diagram unit: mm
|
